MAXDATA VISION 450T User Manual download pdf (Page 67)

Section 5 TROUBLE SHOOTING

5-13

Network Adapter Problems

The Ethernet adapter does not work –

n Go to [Start > Settings > Control Panel] and double click

the System icon. Select the Device Manager tab from the

System Properties. Double-click on Network Adapters and

check if SiS 0900 PCI Fast Ethernet Adapter appears as

one of the adapters. If it does not exist, Windows has not

detected the SiS adapter or the device driver has not been

installed. If there is a yellow mark or red cross on the SiS

network adapter, there may be a device or resource conflict.

Consult Windows manual on how to solve this problem.

n Make sure the physical connections on both ends of the

cable are good.

n The hub or concentrator may not be working properly. Check

to see if other workstations connected to the same hub or

concentrator are working.

n Repeat the undock and then dock sequence.

n Try restarting Windows with the port replicator already

connected to the network.

The Ethernet adapter does not appear to operate in the

100Mbps transmission mode –

n Make sure the hub you are using supports 100Mbps

operation.

n Make sure that your RJ-45 cable meets the 100Base-TX

requirements.

n Make sure the Ethernet cable is connected to the hub‘s

socket that supports 100Base-TX mode. The hub may have

both 100Base-TX and 100Base-T sockets.

PC Cards do not function-

n Make sure you have properly installed the driver for the card.

n Consult the card`s manual or contact the vendor for trouble-

shooting.

PC Card (PCMCIA) Problems

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 87 88

No comments

MAXDATA VISION 450T User Manual Page 67